VK3FR Frame- 1345W x1220H Welded

This kit can go behind the front seats of a van but if installing behind the front seats please be aware that this frame is full height and rear visibility for the driver will be affected. Or it can be installed down the side of a van, most commonly over one of the rear wheel arches as in most vans it matches the distance from the rear door to the sliding door. This is a bolted frame.

This frame suits any of the 630mm wide trays and can take a maximum of ten trays depending on the tray size (fives trays in each bay). The upright post has 18 slots above the bottom bar. 

The frame is constructed from 25.4mm square mild steel tube with a 1.6mm wall. It is made from New Zealand steel which is fabricated and powder coated in New Zealand.

Installation: The upright square posts fit over the round upright post welded to the foot. The foot is tek screwed to the floor and the top brackets are fixed to the side of the van or nearest supporting structure.  

Installation instructions are available in the documents tab.

Dimensions: 1220mm high x 1345mm wide